Check High Pressure Cut In Switch

Fault in the high pressure reset (cut-in) switch or its circuit.

Possible causes

Defective Cut-In switch
System pressure does not drop enough
Internal sensor contact failure
Inconsistent electrical connection

Recommended actions

Verify when the switch activates and deactivates
Inspect the switch wiring harness
Compare with pressure gauge readings
Replace component if it does not close the circuit

Can't find your code? Talk to an expert

$150

One-on-one phone session with a Low Temp refrigeration tech. Emergency temporary assistance only.

Email (opcional)

Teléfono (opcional)

¿Tienes un cupón?

I understand this is emergency temporary remote guidance only, no repair is guaranteed, I assume all risks, and Low Temp Service is not liable for cargo, engine, electrical, mechanical or accident damages. I accept the Terms & Conditions.

Have a question? Ask the community

Thousands of refrigeration mechanics read and answer for free. Post your case in under 1 minute.

Other Thermo King codes

00No Alarms Exist 02Check Evaporator Coil Sensor (Zone)03Check (Control) Return Air Sensor (Zone)04Check (Control) Discharge Air Sensor (Zone)05Check Ambient Temp Sensor 06Check Coolant Temp Sensor

View all Thermo King codes

Need a professional diagnosis?

Low Temp Service — refrigeration experts in Florida.