Sensor Input Voltage High INP1

The input voltage for sensors on the INP1 board is too high.

Possible causes

Alternator overcharging the system
Failure in the board voltage regulator
External high voltage interference

Recommended actions

Check alternator voltage output
Review voltage regulators in the control cabinet
Inspect system grounds
Replace INP1 board if it does not regulate input voltage

Can't find your code? Talk to an expert

$150

One-on-one phone session with a Low Temp refrigeration tech. Emergency temporary assistance only.

Email (opcional)

Teléfono (opcional)

¿Tienes un cupón?

I understand this is emergency temporary remote guidance only, no repair is guaranteed, I assume all risks, and Low Temp Service is not liable for cargo, engine, electrical, mechanical or accident damages. I accept the Terms & Conditions.

Have a question? Ask the community

Thousands of refrigeration mechanics read and answer for free. Post your case in under 1 minute.

Other Carrier Transicold codes

00001Low Fuel Level Warning 00002Low Engine Oil Level Warning 00003Low Coolant Level 00004Low Refrigerant Level AL10Alarm 10 – Supply Air Temperature Sensor (SATS) Out of Range 00011Check/Low Engine Oil Pressure

View all Carrier Transicold codes

Need a professional diagnosis?

Low Temp Service — refrigeration experts in Florida.